You can install the camera wherever you feel inclined with our unique toxic-free silicon tail. When the baby is around 0~8 month, we suggest that you wrap it around the cot. When the baby is around 9~36 months, we suggest that you use our wall mount to place the camera in the living room or playroom for further instant feedback of the baby.
Binding Lollipop Baby Camera with bond

1. Turn the Lollipop to the back, then push BOND to the top.

2. Behind the stick across the crib, the end of the stick should not go higher than BOND!

3. Put the bending tip through the BOND's back hole.

4. Push down the BOND until it touch the crib while pull-up the bottom stick to the crib tightly.

5. Bend the camera and plug-in the USB cable. The USB CABLE can be embedded on the slot.
Bending Lollipop Baby Camera on the thicker crib

1. Put the stick on the side of the crib.(suggested that in the place of 1/3 length)

2. Bend down the end part of the stick. And bend up 1/3 length near the camera side of the stick.

3. Pull up the Camera and slightly pinch the back-side part of the stick.

4. Pull down Lollipop to clamp to the side of the crib and make it tighten.

5. Finish the installation of Lollipop on the thicker crib.