Lollipop Baby Camera comes with a customed wall mount to keep the camera out of your child's reach, which is a warm childlike home design.
We provide the piece with a 3M sticker which could afford 4 times weight of the wall mount after tested. This allows you to position the wall mount without drilling into the wall. The screw is also included in the package.
Follow the below steps to install your camera with the wall mount:
1. Use an alcohol swab to clean the wall. Then, make sure the wall is fully clean and dry. An undecorated, smooth surface without any wallpaper or paint is the ideal surface for the adhesive wall mount piece.

2. Remove the red liner. Place the wall mount piece on the wall following the same direction as the word “up'' and press it firmly for about 60 seconds. Wait 24 hours before hanging the wall mount.

3. Twining your camera around the wall mount.

4. Tilt the wall mount 45 degrees to buckle up the piece.

5. Turn the wallmount clockwise. Installation finished!

🍭If you need to place the wall mount near to your baby’s crib, please use screws instead of sticker, to prevent any unexpected fallen accident.
🍭Need more help? Tell us how we can help.
Submit a request and we’ll provide further assistance.
Get Lollipop Support >
How Do I Install Lollipop Baby Camera With a Silicone Tail and Bond?