Lollipop Baby Camera comes with a wall mount set to keep the camera out of your child's reach, while maintaining its playful and warm design.
The included round mounting pieces with 3M adhesive pad allow you to easily mount your camera onto your walls and enable you to position the camera anywhere without the need to drill into the wall. However, screws are also included in the package if you wish to secure the wall mount and the camera more firmly.
π We suggest you install the round mounting piece onto the wall first before installing the wall mount onto it. They are designed to be tightly fit when installed, and it is difficult to twist the mounting piece into place using bare hands without additional leverage.
Follow these steps to install your camera with the wall mount
- Use the included alcohol swab to clean the wall surface the mounting piece to be stick onto. Make sure the surface is fully dry and clean before applying the mounting piece. Ideally, the surface should be undecorated and smooth without any wallpaper or paint.
-
Remove the protective film and place the mounting piece on the wall. Be aware of the orientation of the arrow, as it should point upwards and match the one on the wall mount when fully installed. Press firmly for about 60 seconds. Please then wait 24 hours to allow it to fully adhere before installing the wall mount.
-
Wind your camera around the wall mount.
-
Tilt the wall mount 45 degrees up and buckle up the piece.
-
Turn the wall mount clockwise. Installation finished!
π If you are placing the wall mount near your baby's crib, we recommend using the screws instead of the adhesive pad to prevent unexpected accidents.
π Need more help? Tell us how!
Submit a request and we will provide further assistance.
Get Lollipop Support >How Do I Install Lollipop Baby Camera With a Silicone Tail and Bond?